Toa VX-2000SF - Page 139

Chapter 7: PC SOFTWARE OFFLINE SETTINGS
7. CONFIGURATION SETTING MODE
7-24
Step 6. Press the [OK] button after completing the settings of all Remote Microphones.
The following message will then be displayed.
"Data altered in all opened properties windows will be saved and RM properties settings completed.
OK?"
Step 7. Click on the [Apply] button to update and save the settings, and click on the [OK] button to close the
[RM Properties] window. To continue the setting procedure, click on the [Cancel] button. The screen
will return to the Properties settings.
Tip
All RM properties windows can also be simultaneously closed by selecting [Edit
RM Properties Setting End]
from the menu.
[Remote microphone Unit ID Number]
• ThenumberdisplayedontheleftoftheRemotemicrophoneiconrepresentstheUnitIDnumber.TheUnitID
numbers of Remote Microphone set for [Emergency] broadcast type are displayed in red, while those set for
[General] are displayed in blue.
• TheRM-200XForRM-200XUnitIDNumbercanbesetbytheunit'sDIPswitch.Makesurethattheequipment
Unit ID number and connection match up with those on the Configuration screen. Refer to
p. 8-3 for the Unit
ID Number setting.
[Pop-up menu operation to change the VX-2000SF configuration]
On the Configuration screen, erasure of the sound source and input module, and whether or not to use a sound
source as BGM can be performed as well. This configuration change can be executed by clicking the right
mouse button over the corresponding equipment block and selecting the operation from the pop-up menu that
appears.
Unit ID number