NETS
WORKING WITH NETS
184 ENVOY™ TRANSCEIVER REFERENCE MANUAL
1 Press or to select the value that you want to use from the following:
• To make calls from this station to the NET, select Enabled.
• To prevent calls being made from this station to the NET, select
Disabled.
1 Press to move to the In Calls entry.
1 Press or to select the value that you want to use from the following:
• If your station has the NET programmed and you want to receive calls
from the NET, select Enabled.
• If your station has the NET programmed but you are not a member, and
you do not want to receive any of the NET calls, select Members only.
• If your station is a member of the NET but you do not want to receive any
calls from the NET, select Disabled.
1 Press to move to the Link entry.
1 Press or to select the value that you want to use from the following:
• If you want to know with which member stations you have linked, select
Only if response.
• If you do not need to know which of the member stations enter the link,
select Even if no response.
• If you want to link without the delay of the link establishment process,
select Immediately.
1 Press to move to the Response entry.
1 Press or to select the value that you want to use from the following:
• If you want the station to confirm that it has received the link request,
select Send.
• If you want the station to remain silent when it receives the link request
but still enter the link, select Do not send.
1 Press to move to the Tune Time entry.
1 Press or to select the longest time required for tuning antennas within the
NET.
1 Press to move to the LQA Exchange entry.
1 Press or to select the value that you want to use from the following:
• If you want the station to add time to the slot for LQA exchange, select
Enabled.
• If you do not want the station to add extra time to the slot, select
Disabled.
1 Press to move to the Slot Width entry.
To Next Page
Loading...
Need help?
General
