INTRODUCTION
2 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Access rights—provides an overview of access rights that may be set via TPS, and
how this affects access to entries in the user interface of the control point
Keys and macros—provides a summary of the standard hot keys on the control point,
and describes how to add your own macro and assign this to a hot key
Modes—provides a summary of the modes that may be available in your transceiver
Free tune—describes how to tune to a specific receive frequency
IP remote control—provides an overview of the typical operational scenarios that use
IP remote control
Data options—describes how to set up and use modems with the transceiver
Encryption—describes how to set up and use encryption with the transceiver
Connectors—provides a summary of the pinouts of all connectors in the transceiver
system
Specifications—provides specifications for the transceiver system
Installation—describes how to install the transceiver and antenna in a mobile or fixed
situation, and how to test the installation
LED indications—describes the status of the RFU
HF radio transmission—provides an overview of communication using the medium
of HF radio
Call types and features—describes each call type, the special ALE address syntaxes
that can be used with these call types, and special features that may be included with
a call
Definitions—explains the terms and abbreviations used in this manual
Compliance—provides information on the compliance standards that have been
attained for the product
Licence information—references licence information for all open source components
of the firmware
To Next Page
Loading...
Need help?
General
