CDM-625 Advanced Satellite Modem Revision 13
Front Panel Operation MN-CDM625
5–66
After defining and enabling an access list via SNMP or the CDM-625 Web Server interface
‘Admin | Access’ page, functionality of this menu appears as follows:
Host Access List is Enabled
Disable the List: No (N,Y) ()
Use the
▲▼ arrow keys to select N (No) to maintain the active Host Access List, or Y to disable
the list. Press ENTER when done. Once disabled, the following message appears whenever this
menu is selected:
Host Access List is Disabled
Use HTTP or SNMP to configure the list.
5.2.1.13.6 CONFIG: IP PktP-Enable
This menu is visible/selectable only when the optional IP Packet Processor card is
installed.
Packet Processor: Enabled (Ena, Dis) ()
(Modem will auto-reboot after change!)
Use the
▲▼ arrow keys to select the card as Ena(bled) or Dis(abled), and then press ENTER. The
modem will automatically reboot after this configuration change. Note the following:
• The default mode is Ena(bled).
• When the IP Packet Processor is disabled, the card and its accompanying functionality is
completely bypassed and the modem reverts to its base modem Layer 2 switch
functionality.
To Next Page
Loading...
