Comtech EF Data CDM-625 - CDM-625 Ethernet Overview; Introduction; Interface Architecture; Figure 16-1. CDM-625 Ethernet Architecture Design

16–1
Chapter 16. ETHERNET
NETWORK CONFIGURATION
16.1 Introduction
The CDM-625 Advanced Satellite Modem’s handling of Ethernet terrestrial traffic data differs
depending on whether the optional IP Packet Processor is either not installed or installed but
disabled; or when the optional IP Packet Processor is installed
and enabled.
Chapter 18. IP PACKET PROCESSOR OPTION
This chapter explains the CDM-625’s Ethernet interface and illustrates the functional differences
between the available operating modes. Additional modes of operation are also explained.
16.2 CDM-625 Ethernet Overview
16.2.1 Interface Architecture
Figure 16-1. CDM-625 Ethernet Architecture Design
Figure 16-1 shows the internal Ethernet architecture for the CDM-625. The CDM-625 features
four built-in 10/100 BaseT Ethernet Ports (port configuration and statistics are available on a
per-port basis) connected to a single internal Ethernet Layer 2 Managed Switch.