CDM-625 Advanced Satellite Modem Revision 13
Appendix D MN-CDM625
D–7
D.5 Remote Commands and Queries
D.5.1 Table Indexes
Notes:
1. Index Columns – Where Column ‘C’ = Command, and Column ‘Q’ = Query, columns marked ‘X’ designate the instruction code as
Command only, Query only, or Command or Query. Where CODE = XXX, this indicates a priority command.
2. In the tables that follow, the following codes are used in the ‘Response to Command’ column (per Sect. D.5.5):
# Message ok, but unit is not in Remote mode.
? Received ok, but invalid arguments were found. ~ Time out of a pass-through message, either to via EDMAC or to a local ODU
^ Message ok, but unit is in Ethernet mode.
Sect. D.5.2 Tx Parameters
CODE C Q PAGE
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
CODE C Q PAGE
APP X X D-16
TBA X X D-17
TFQ X X D-13
TMX X X D-13
TTF X D-18
AUP X X D-15
TCI X X D-17
TFT X X D-11
TPL X X D-14
TVL X X D-17
DTS X X D-17
TCK X X D-16
TIR X D-18
TRS X X D-14
TXA X X D-15
DTY X X D-17
TCR X X D-12
TIT X X D-10
TSC X X D-14
TXO X X D-15
TDI X X D-14
TLO X X D-18
TSI X X D-14
PLI X D-16
TDR X X D-13
TMD X X D-11
TSR X X D-13
TET X X D-18
TMI X D-18
TTA X X D-17
REB X D-16
TFM X X D-10
TMR X X D-13
TTC X X D-17
Sect. D.5.3 Rx Parameters
CODE C Q PAGE
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
CODE C Q PAGE
ITS X X D-25
RCK X X D-24
RFQ X X D-22
RMX X X D-22
To Next Page
Loading...
