Comtech EF Data CDM-625 - F.5.1 ODU Operations Using the Telnet CLI; F.5.1.1 Home (Main) Menu

CDM-625 Advanced Satellite Modem Revision 13
Appendix F MN-CDM625
F–55
F.5.1 ODU Operations using the Telnet CLI
1. ODU Comms must be Enabled, and the CDM-625 must be configured for 70/140
MHz operation in order to fully use the Telnet CLI ODU menus.
2. The Comtech EF Data KST-2000A/B Transceiver and LPOD Amplifier / Block Up
Converter are not supported by the Telnet CLI at this time.
F.5.1.1 Home (Main) Menu
The Home Menu serves as the CLI’s primary navigation page. Press the ‘E’ hot key to access the
ODU submenus.
Hot Key
Description
Function
A
Administration
Access administrative configuration submenu
B
Modem
Access modem configuration submenu
C
Network
Access network configuration submenu
D
WAN
Access WAN configuration submenu
E
Outdoor Unit (ODU)
Access ODU comms, CSAT-5060 configuration submenus
F
Redundancy
Access 1:1 or 1:N redundancy configuration submenu
G General Information
Enter alphanumeric Circuit ID; view read-only CDM-625 operations information
screens
H Logs
Access Base Modem and Packet Processor stored events and statistics logs,
alarms control submenus
I
Statistics
Access CDM-625 operational statistics submenus
J
Contact
View read-only Customer Support contact information screen
K
Remote Mode
Open the Remote Access Mode setting