Comtech EF Data CDM-625 - Figure 6-1. CDM-625 Telnet Command Line Interface (CLI); Using the Telnet Interface for Telnet Command Line Interface (CLI) Operation

CDM-625 Advanced Satellite Modem Revision 13
Ethernet-based Remote Product Management MN-CDM625
6–7
6.4.2 Using the Telnet Interface for Telnet Command Line Interface (CLI)
Operation
Appendix E. TELNET COMMAND LINE INTERFACE (CLI) OPERATION
Figure 6-1. CDM-625 Telnet Command Line Interface (CLI)
(Left) TeraTerm CLI Example
(Right) PuTTY CLI Example
1. The CDM-
625 Telnet Command Line Interface (CLI) is accessible only when the
optional IP Packet Processor is installed and enabled.
2. The CDM-625 Telnet CLI uses Telnet TCP Port 107. Be sure to specify this port
when configuring your terminal emulator for CLI operation.
3.
The HyperTerminal terminal emulator, while compatible for use with remote
control operations, is not supported or recommended for CDM-625 Telnet CLI
operation. Instead, for best results Comtech EF Data recommends PuTTY or
Tera Term or as the preferred terminal emulators (Figure 6-1).