CDM-625 Advanced Satellite Modem Revision 13
Appendix C MN-CDM625
C–3
For Firmware Ver. 1.5.1 or earlier, enter the FAST access code for option
register(s) #1, #2 and/or #3 as required. For Firmware Ver. 1.5.2 and
later, all three FAST access codes must be entered in sequence in order
for the purchased option upgrades to be properly activated.
The m odem responds with “Configured Successfully” if the FAST upgrade is accepted; the m odem
then resets to its newly-incorporated default configuration.
However, if an invalid code is entered, the following message displays:
Failed to configure. Re-enter code.
88888888888888888888 then [ENTER]()
Repeat the FAST access code entry procedure. Should the code entry error persist, contact Comtech
EF Data Customer Support for further assistance.
To Next Page
Loading...
