* z=Rx Clock Invert
* O=EDMAC mode
* EEEE=EDMAC Address
T=Unit Test Mode
* eeeeeeeeeeeee=Unit Alarm Mask
W=Hi-Stab Reference choice
A=Statistics Sampling Interval
L=Rx Terrestrial Alarm Enable
Q=Tx Terrestrial Alarm Enable
U=ODU Common Enable
HHHH=Tx Backward Alarm
hhhh=Rx Backward Alarm
JJJJ=Tx Audio Volume
jjjj= Rx Audio Volume
a=Drop Type
b=Insert Type
c=Tx ESC Type
d=Rx ESC Type
e=Tx Data Invert
f=Rx Data Invert
* A=Tx Sub-Mux on/off
* B=Rx Sub-Mux on/off
* CC=Tx Sub-Mux Ratio
* DD=RX Sub-Mux Ratio
* mMAT
* rrrrr.rrr=TX Symbol Rate
* sssss.sss=RX Symbol Rate
* h=HSSI handshake control
* g=RTS/CTS setting
k=Rx Equalizer Enable
p=Power-On/Carrier-Off Enable
m=ESC enable
nnn=ESC parameters
tt=G.703 Clock Extension
* uuu.uuu.uuu.uuu.uu=IP address
* vvv.vvv.vvv.vvv=IP gateway address
* w
* G=Tx BERT State
* H=Tx BERT Pattern
* I=BERT 10E-3 Error Insert
* J=Rx BERT State
* K=Rx BERT Pattern
* w=CnC mode
* AAA=CnC frequency offset
BBBCCC=CnC search delays