Datalogic AV7000 User Manual

OPERATING MODE
PRODUCT REFERENCE GUIDE 113
Green Spot Settings AV500 Only
Green Spot Mode
Select one of the following from the drop-down list:
•Disabled
•Good Read - Immediate: this option will light the green LED at the time of the bar code
being decoded. In an array only the camera that read the bar code will light.
•
Good Read - Host Transmission: this option will light the green LED when the package
reaches the transmit point. In the on-line mode it will light when the trailing edge of the
package leaves the trigger photo sensor. In the Packtrack mode it will light when the defined
edge of the package, leading or trailing, arrives at the Distance To Transmit Point setting.
Green Spot On Time
Specify the amount of time in milliseconds that the Green Spot should remain on.
X-Press Button Settings AV500 Only)
X-Press Functionality
Select Enabled or Disabled from the drop-down.
Redundant Controller Settings
If your system requires redundant operation, these settings needs to be defined.
Use GPIN to Indicate Active Controller
Click the check-box to use GPIN to indicate the Active Controller. If this is selected, Input 3 of
the primary and secondary controllers are set to indicate the active controller.
Disable Error Detection Switchover
Click this check-box to disable Error Detection Switchover. If checked the Switchover
Parameters will not be available.
Allow SC5000 to Control Switchover
Click this check-box and the SC5000 controller will determine the switchover. The previous two
parameters will not be available.
Controller Mode: Camera_1
Select the Controller Mode for the specific camera. This options appears for every AV family
camera in the system.
•
Auto-Detect: this option is used when multiple cameras are used in an array and there are
two CBX’s. All units in the array will check the status of the bit created by the IDNet jumper.
The one that identifies the connection will become the controller. This option is used when
the camera is in a redundant application. In this configuration there are two camera's that
will be connected to a CBX510. When Auto-Detect is selected the camera that initializes first
will become the DHCP controller and assume the 192.168.0.145 IP. The Secondary Controller

Datalogic AV7000 Specifications

General

Brand	Datalogic
Model	AV7000
Category	Digital Camera
Language	English