Datalogic Magellan 9300i User Manual

Programming Overview
Product Reference Guide 101
Test Mode
Use this feature to place the scanner into a testing, or “demo” mode. This spe-
cial mode disables the scanner interface, meaning that bar code data is not sent
out to the host via the scanner interface. This allows the bar code to be scanned
continuously without requiring a response from the POS terminal.
Enable Test Mode — The scanner will scan labels and beep without sending data.
Disable Test Mode — The scanner will return to the original configuration before
Test Mode was entered.
TEST MODE = DISABLE
TEST MODE = ENABLE
NOTE
DO NOT scan the Enter/Exit Programming Mode bar code before and
after scanning the bar codes on this page.

Datalogic Magellan 9300i Specifications

General

Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Standard interfaces	RS-232
Connectivity technology	Wired
Product color	Black, Grey
Built-in display	No
Sustainability certificates	RoHS

Weight and Dimensions

Weight	- g