Datalogic Magellan 9300i - Code 93; Code 93 Enable

Enter/Exit Programming Mode
Product Reference Guide 397
Code 93
Code 93 Enable
Enables/disables the ability of the scanner to decode Code 93 labels.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Code 93 = Disable
Code 93 = Enable
DEFAULT
009100(CR)
009101(CR)