Enter/Exit Programming Mode Interface Related Features
218 Magellan™ 9300i / 9400i Scanners
USB OEM Interface Options
The OEM-USB interface offers specific control over interaction with certain
devices. Options for this feature are as follows:
• FULL host interface support — Accepts scanner and scale configuration
host commands.
• Compatible with Magellan SL host interface support — Uses Magellan SL
host interface support.
• Ignore host interface configuration of scanner and scale — Ignores all
scanner and scale configuration host commands.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
This feature applies only to the USB OEM
interface. For other IBM interfaces, refer to
the feature,
IBM Interface Options on
page 212, earlier in this section.
USB OEM Interface Options = Full Interface Support
USB OEM Interface Options = Compatible with Magellan SL
Host Interface Support
USB OEM Interface Options = Ignore Host Interface
Configuration of Scanner and Scale
DEFAULT