Enter/Exit Programming Mode 1D Symbology Programming
308 Magellan™ 9300i / 9400i Scanners
EAN-8 Stitch Unlike Label Halves
This setting enables the stitching of two EAN-8 label halves together that may
have different characters.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
EAN-8 Stitch Unlike Label Halves = Disable
EAN-8 Stitch Unlike Label Halves = Enable
DEFAULT
To Next Page
Loading...
