Datalogic Magellan 9300i - Code 128 Minimum Read

Enter/Exit Programming Mode 1D Symbology Programming
368 Magellan™ 9300i / 9400i Scanners
Code 128 Minimum Read
This feature specifies the minimum number of consecutive Code 128 decodes
before is accepted as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Code 128 Minimum Read = 1
Code 128 Minimum Read = 2
Code 128 Minimum Read = 3
Code 128 Minimum Read = 4
DEFAULT
006F01(CR)
006F02(CR)
006F03(CR)
006F04(CR)