Enter/Exit Programming Mode
Product Reference Guide
427
GS1 Datamatrix Enable
Enables/disables the ability of the scanner to decode GS1 Datamatrix labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
GS1 Datamatrix disabled
GS1 Datamatrix enabled
DEFAULT
To Next Page
Loading...
