Enter/Exit Programming Mode 1D Symbology Programming
384 Magellan™ 9300i / 9400i Scanners
Codabar
Codabar Enable
Enables/disables the ability of the scanner to decode Codabar labels.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Codabar = Disable
Codabar = Enable
DEFAULT
To Next Page
Loading...
