Datalogic Magellan 9300i - EAS Good Beep Mode

Enter/Exit Programming Mode EAS Features
190 Magellan™ 9300i / 9400i Scanners
EAS Good Beep Mode
This feature sets the mode of operation for the EAS deactivation beep while
operating in coupled mode.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
EAS Good Beep Mode = Disable
EAS Good Beep Mode = Beep on Deactivate
EAS Good Beep Mode = Beep on Verify
DEFAULT
058A00(CR)
058A01(CR)
058A02(CR)