Datalogic Magellan 9300i - Parity

Enter/Exit Programming Mode
Product Reference Guide 225
RS-232 Parity
Specifies parity required for sending and receiving data.
Options for this setting are:
• RS-232 PARITY = NONE
• RS-232 PARITY = EVEN
• RS-232 PARITY = ODD
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code below or on the following pages representing the
desired Parity setting. You’ll need to cover any unused bar codes, as well
as facing pages to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
A setting of no parity with 7 data bits will default to 8
data bits and no parity.
RS-232 Parity = None
RS-232 Parity = Even
RS-232 Parity = Odd
DEFAULT
001F00(CR)
001F01(CR)
001F02(CR)