Datalogic Magellan 9300i - Number of Data Bits

Enter/Exit Programming Mode
Product Reference Guide 223
RS-232 Number of Data Bits
Specifies number of data bits required for sending and receiving data.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code below representing the desired Data Bit setting. You’ll
need to cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
A setting of 7 data bits with no parity will default to 8
data bits and no parity.
RS-232 Number of Data Bits = 7
RS-232 Number of Data Bits = 8
009B00(CR)
009B01(CR)
DEFAULT