Datalogic Magellan 9300i User Manual

100 Magellan™ 9300i / 9400i Scanners
LED and Beeper Indicators
The scanner provides a set of indicators that verify/announce the various scan-
ner functions. See Appendix A for more details.
If You Make a Mistake...
If, during a programming session, you find that you are unsure of the scanner’s
settings or wish to reset the scanner’s configuration, use the Return to Factory
Settings label below to return the scanner’s configuration to the factory set
-
tings. Scanning this label will also reset any changes made during previous
programming sessions.
Return to Factory Settings
Scan the bar code below to return the scanner to the default settings config-
ured at the factory for the currently active interface. This bar code is typically
used to return the scanner to a “known” operating state when the present pro
-
gramming status is not known, faulty, or suspect.
RETURN TO FACTORY SETTINGS
CAUTION
Use this bar code with caution, since it will reset ALL features that
may have been programmed since the scanner’s installation.
NOTE
DO NOT scan the Enter/Exit Programming Mode bar code before and
after scanning this bar code.

Datalogic Magellan 9300i Specifications

General

Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Standard interfaces	RS-232
Connectivity technology	Wired
Product color	Black, Grey
Built-in display	No
Sustainability certificates	RoHS

Weight and Dimensions

Weight	- g