Enter/Exit Programming Mode 1D Symbology Programming
324 Magellan™ 9300i / 9400i Scanners
EAN Two Label Combined Transmission
Enables/disables the transmitting of an EAN two label pair as one label.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
EAN Two Label Combined Transmission = Disable
EAN Two Label Combined Transmission = Enable
DEFAULT