Datalogic Magellan 9300i - Good Read Beep Volume

LED and Beeper Indicators Enter/Exit Programming Mode
Product Reference Guide 151
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are five selectable
volumes, with each volume increment adding approximately five decibels to the
previous level:
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code.
•Low •Medium High
•Medium Low •High
•Medium
Good Read Beep Volume = Low
Good Read Beep Volume = Medium Low
Good Read Beep Volume = Medium
Good Read Beep Volume = Medium High
Good Read Beep Volume = High
001900(CR)
001901(CR)
DEFAULT
001902(CR)
001903(CR)
001904(CR)