Datalogic Magellan 9300i - Good Read Beep Frequency

LED and Beeper Indicators Enter/Exit Programming Mode
Product Reference Guide 149
Good Read Beep Frequency
Adjusts the scanner’s good read beep to sound at low, medium, or high fre-
quency (controls the beeper’s pitch/tone).
•Low
•Medium
•High
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Good Read Beep Frequency = Low
Good Read Beep Frequency = Medium
Good Read Beep Frequency = High
001400(CR)
001401(CR)
DEFAULT
001402(CR)