Enter/Exit Programming Mode 1D Symbology Programming
342 Magellan™ 9300i / 9400i Scanners
DataBar Expanded
DataBar Expanded Enable
Enables/disables the ability of the scanner to decode DataBar Expanded labels.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
This value-added feature is a factory-programmed option.
Contact your dealer for information about upgrading your
system to include this advanced capability.
DataBar Expanded = Disable
DataBar Expanded = Enable
DEFAULT