Datalogic Magellan 9300i - EAS Features - Checkpoint; ERI Active State

Enter/Exit Programming Mode EAS Features
200 Magellan™ 9300i / 9400i Scanners
EAS Features — Checkpoint
The features in this section apply only to Checkpoint
®
EAS systems.
ERI Active State
Specifies the active state polarity of ERI; the inactive state is its opposite polar-
ity. ERI output goes active during the good read of a bar code, allowing the EAS
device to deactivate a tag on the product.
To set the ERI Active State:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
ERI Active State = Active Low
ERI Active State = Active High
DEFAULT
00F900(CR)
00F901(CR)