Enter/Exit Programming Mode EAS Features
188 Magellan™ 9300i / 9400i Scanners
EAS Notification
This feature specifies the output mode and activation of EAS event notification
when operating in Coupled Mode.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
EAS Notification = Disable
EAS Notification = Notification over POS Port
DEFAULT
To Next Page
Loading...
