Enter/Exit Programming Mode Interface Related Features
254 Magellan™ 9300i / 9400i Scanners
Single Cable RS-232 Pacesetter Plus
This option enables the scanner’s ability to send Pacesetter Plus information as
trailers to UPC/EAN bar codes.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Single Cable RS-232 Pacesetter Plus = Do Not Send
Single Cable RS-232 Pacesetter Plus = Send
DEFAULT
To Next Page
Loading...
