Datalogic Magellan 9300i - Global Suffix

Enter/Exit Programming Mode Data Editing
270 Magellan™ 9300i / 9400i Scanners
Global Suffix
This feature applies to RS-232 interfaces (Standard, Wincor-Nixdorf, and Single
Cable). It specifies the suffix that is added to end of a label transmission. Three
standard options are available below. Contact your dealer for other alternate
settings for this feature.
•No Global Suffix
• CR — Carriage Return
• CR LF — Carriage Return, Line Feed
To set the Global Suffix:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Global Suffix = No Global Suffix
Global Suffix = CR
Global Suffix = CR LF
031E00(CR)
031E0D00(CR)
DEFAULT
031E0D0A00(CR)