Datalogic Magellan 9300i - Label ID; Label ID Control

Enter/Exit Programming Mode Data Editing
272 Magellan™ 9300i / 9400i Scanners
Label ID
Label ID Control
This feature specifies whether or not Label IDs are transmitted to the host and
if so, whether to attach them as a prefix or suffix.
Choices are:
•Disable
• Enable as a Prefix
• Enable as a Suffix
To select the option for Label ID Control:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the desired option from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Label ID Control = Disable
Label ID Control = Enable as a Prefix
Label ID Control = Enable as a Suffix
020500(CR)
020501(CR)
DEFAULT
020502(CR)