Datalogic Magellan 9300i User Manual

Enter/Exit Programming Mode 1D Symbology Programming
394 Magellan™ 9300i / 9400i Scanners
Codabar Length 2
If Codabar Length Control is set to Fixed-Length decoding, this feature speci-
fies Codabar second fixed length. If Codabar Length Control is set to Variable-
Length decoding, this feature specifies the maximum label length.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the bar code, Set Codabar Length 2 on page 394 below. You’ll need
to cover any unused bar codes on this and the facing page to ensure that
the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired label length. The selectable range for this
option is 00 (meaning ignore this length), or 03 to 50. Pad all single digit
numbers with a leading zero to yield a two-digit entry (03-50).
4. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
When in Fixed Length mode, if Length 2 is set to the value
of 00 (zero), then only Length 1 will apply.
Set Codabar Length 2
Default setting for this feature = 32
0239(CR)
DEFAULT

Datalogic Magellan 9300i Specifications

General

Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Standard interfaces	RS-232
Connectivity technology	Wired
Product color	Black, Grey
Built-in display	No
Sustainability certificates	RoHS

Weight and Dimensions

Weight	- g