Datalogic Magellan 9300i - EAN-13 First Character Transmission

Enter/Exit Programming Mode 1D Symbology Programming
296 Magellan™ 9300i / 9400i Scanners
EAN-13 First Character Transmission
Enables/disables transmission of EAN/JAN-13 first character.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
This item is ignored when the advanced feature, Full Label
Edit, is enabled.
EAN-13 First Character Transmission = Disable
EAN-13 First Character Transmission = Enable
024400(CR)
024401(CR)
DEFAULT