Enter/Exit Programming Mode 1D Symbology Programming
388 Magellan™ 9300i / 9400i Scanners
Codabar Check Character Calculation
Enables/disables calculation and verification of an optional Codabar check
character.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
If check character calculation is disabled, the risk is
increased that a misread can occur. When disabled, any
check characters in a bar code are treated as data charac
-
ters.
Codabar Check Character Calculation = Disable
Codabar Check Character Calculation = Enable
DEFAULT
To Next Page
Loading...
