Enter/Exit Programming Mode
Product Reference Guide
253
Single Cable RS-232 Datalogic Extensions
When Datalogic extensions are enabled, scale calibration mode information is
communicated to the host. Contact Customer Support for the format of this
information. Choices for this feature are:
• Standard Protocol
• Support Datalogic Extensions to Protocol
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Single Cable RS-232 Datalogic Extensions = Standard Proto-
col
Single Cable RS-232 Datalogic Extensions = Support Datalogic
Extensions to Protocol
DEFAULT
To Next Page
Loading...
