Datalogic Magellan 9300i User Manual

Enter/Exit Programming Mode
Product Reference Guide 333
GS1 DataBar
The symbology family, GS1 DataBar
TM
, was formerly known as Reduced Space
Symbology (RSS). For the purpose of simplicity, GS1 DataBar variants are listed
in this manual as “DataBar.”
DataBar Omnidirectional
DataBar Omnidirectional Enable
Enables/disables the ability of the scanner to decode DataBar Omnidirectional
labels.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
This value-added feature is a factory-programmed option.
Contact your dealer for information about upgrading your
system to include this advanced capability.
DataBar Omnidirectional = Disable
DataBar Omnidirectional = Enable
DEFAULT
04D000(CR)
04D001(CR)

Datalogic Magellan 9300i Specifications

General

Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Standard interfaces	RS-232
Connectivity technology	Wired
Product color	Black, Grey
Built-in display	No
Sustainability certificates	RoHS

Weight and Dimensions

Weight	- g