Datalogic Magellan 9300i - Scanner Control Button Options

Enter/Exit Programming Mode General Scanner and Scale Features
146 Magellan™ 9300i / 9400i Scanners
Scanner Control Button Options
Configure the Scanner Control Button to one of the following modes of opera-
tion:
• Enable all functions: Volume, tone, diagnostics and reset.
• Enable only volume, tone and reset.
• Enable reset only.
• Disable all button functions
To set the desired Scanner Control Button Option:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Scanner Control Button = Enable All Functions
Scanner Control Button = Enable Only Volume Tone and Reset
Scanner Control Button = Enable Reset Only
Scanner Control Button = Disable All Functions
05AF00(CR)
05AF01(CR)
DEFAULT
05AF02(CR)
05AF03(CR)