Enter/Exit Programming Mode General Scanner and Scale Features
174 Magellan™ 9300i / 9400i Scanners
Scale Intercharacter Delay
With regard to scale functions, this feature specifies a delay between the end of
one character and the beginning of the next in 10-millisecond increments.
To set the Scale Intercharacter Delay:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code below, Set Scale Intercharacter Delay on page 174. You’ll
need to cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired delay. The selectable range is 0-255, which is
the delay in 10-millisecond increments. Pad all single and double digit
numbers with leading zeroes to yield a three-digit entry (000-255).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the appro-
priate amount of digits have been scanned.
Set Scale Intercharacter Delay
Default setting for this feature is:
00 - No Intercharacter Delay
DEFAULT
To Next Page
Loading...
Need help?
General
Weight and Dimensions
