Datalogic Magellan 9300i - Scale Sentry Adaptive Scale Indication State

Enter/Exit Programming Mode General Scanner and Scale Features
160 Magellan™ 9300i / 9400i Scanners
Scale Sentry Adaptive Scale Indication State
Defines the indication state of the adaptive Scale Sentry output pin.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Scale Sentry Adaptive Scale
Indication State = Active Low
Scale Sentry Adaptive Scale
Indication State = Active High
04CE00(CR)
04CE01(CR)
DEFAULT