Enter/Exit Programming Mode 1D Symbology Programming
364 Magellan™ 9300i / 9400i Scanners
Code 32 Check Character Transmission
Enables/disables transmission of Code 32 check character.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
This item is ignored when the advanced feature, Full Label
Edit, is enabled.
Code 32 Check Character Transmission = Disable
Code 32 Check Character Transmission = Enable
DEFAULT
To Next Page
Loading...
