Datalogic Magellan 9300i - Interface Selection

Enter/Exit Programming Mode
Product Reference Guide 207
RS-232 Interface Selection
Remember to cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
CAUTION
Great care should be taken to select the correct interface type,
since you can cause damage to the scanner and/or POS termi
-
nal by attempting to change to an incompatible interface.
ALWAYS make interface selections with the host cable DIS
-
CONNECTED.
Interface Type = RS-232 Standard
Interface Type = RS-232 Wincor-Nixdorf
000105(CR)
000112(CR)
NOTE
Single cable installations require connection at the POS Termi-
nal (host) port. The Scale Host port connection is not used for
this interface.
Interface Type = RS-232 Single Cable
000120(CR)