Enter/Exit Programming Mode 1D Symbology Programming
350 Magellan™ 9300i / 9400i Scanners
Code 39
Code 39 Enable
Enables/disables the ability of the scanner to decode Code 39 labels.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Code 39 = Disable
Code 39 = Enable
To Next Page
Loading...
