Datalogic Magellan 9300i User Manual

Enter/Exit Programming Mode General Scanner and Scale Features
130 Magellan™ 9300i / 9400i Scanners
Digitally Watermarked (DWM) Double Read Timeout
Specifies the minimum allowable time which must pass before reading the
same Digitally Watermarked (DWM) label again (e.g. two identical items in suc
-
cession).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code.
NOTE
If the incidence of multiple reads is not acceptable, increase the
Double Read Timeout setting to a higher value.
DWM Double Read Timeout = 0.3 Seconds
DWM Double Read Timeout = 0.4 Seconds
DWM Double Read Timeout = 0.5 Seconds
DWM Double Read Timeout = 0.7 Seconds
DWM Double Read Timeout = 1 Second
00521E(CR)
005228(CR)
DEFAULT
005232(CR)
005246(CR)
005264(CR)

Datalogic Magellan 9300i Specifications

General

Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Standard interfaces	RS-232
Connectivity technology	Wired
Product color	Black, Grey
Built-in display	No
Sustainability certificates	RoHS

Weight and Dimensions

Weight	- g