Datalogic Magellan 9300i - EAN-8 Minimum Read

Enter/Exit Programming Mode
Product Reference Guide 303
EAN-8 Minimum Read
This feature specifies the minimum number of consecutive EAN-8 decodes
before is accepted as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
EAN-8 Minimum Read = 1
EAN-8 Minimum Read = 2
EAN-8 Minimum Read = 3
EAN-8 Minimum Read = 4
DEFAULT
006501(CR)
006502(CR)
006503(CR)
006504(CR)