Enter/Exit Programming Mode Interface Related Features
242 Magellan™ 9300i / 9400i Scanners
RS-232 Indicate Transmission Failure
This feature enables / disables the ability of the scanner to sound a bad label
beep indication when a transmission failure occurs.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the desired option from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
RS-232 Indicate Transmission Failure = Disable
RS-232 Indicate Transmission Failure = Enable
To Next Page
Loading...
