Enter/Exit Programming Mode 1D Symbology Programming
332 Magellan™ 9300i / 9400i Scanners
GTIN
GTIN Enable
Enables/Disables the ability to convert UPCE, UPCA, EAN8, and EAN13 labels
into the GTIN 14-character format.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
If add-on information is present on the base label prior to
the conversion taking place, the add-on information will be
appended to the converted GTIN bar code.
GTIN = Disable
GTIN = Enable
DEFAULT
To Next Page
Loading...
