Datalogic Magellan 9300i - Databar Expanded 2 D Component Enable

Enter/Exit Programming Mode 1D Symbology Programming
344 Magellan™ 9300i / 9400i Scanners
DataBar Expanded 2D Component Enable
When this feature is enabled, the software will not decode an DataBar Expanded
bar code with a 2D component associated with it, and the 2D component will be
discarded.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DataBar Expanded 2D Component = Disable
DataBar Expanded 2D Component = Enable
DEFAULT
04D700(CR)
04D701(CR)