Datalogic Magellan 9300i - Scale Calibration Notification

Scale Features Enter/Exit Programming Mode
Product Reference Guide 173
Scale Calibration Notification
This option enables a notification that scale calibration has taken place.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Scale Calibration Notification = Disable
Scale Calibration Notification = Enable
DEFAULT
033700(CR)
033701(CR)