Enter/Exit Programming Mode 1D Symbology Programming
366 Magellan™ 9300i / 9400i Scanners
Code 128 Transmit Function Characters
Enables/disables transmission of Code 128 function characters 1, 2, 3, and 4.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
Disabled is the recommended setting for all interfaces.
Code 128 Transmit Function Characters = Disable
Code 128 Transmit Function Characters = Enable
DEFAULT
To Next Page
Loading...
