Enter/Exit Programming Mode Interface Related Features
220 Magellan™ 9300i / 9400i Scanners
USB OEM Additional Interface Options
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code
USB OEM Interfaces Option2 =
Enable scanner at first enumeration after BusReset
USB OEM Interfaces Option2 =
Disable scanner at first enumeration after BusReset
To Next Page
Loading...
